Product Overview
Most people who upgrade a laptop end up with a perfectly good M.2 SSD sitting in a drawer. This adapter is the cheapest way to put it back to work: lay the drive into the socket, fix it with the supplied screw, and the whole thing becomes a USB stick that is far faster and far larger than any flash drive. The USB-A plug is part of the circuit board itself, so there is nothing to carry except the board and the drive.
The bridge chip handles both of the protocols M.2 drives use. An NVMe drive, which is the M-key type with a single notch, runs over PCIe; a SATA M.2 drive, the B+M key type with two notches, runs over SATA. The board detects which one is fitted, so you do not have to buy a different adapter for each. On a USB 3.1 Gen 2 port it negotiates 10 Gbps and supports UASP for proper command queueing and TRIM so the drive can keep itself tidy. Plugged into an older USB 3.0 port it still works, just at 5 Gbps.
Before ordering: this is an open circuit board, not a closed enclosure - there is no case, no shielding and no heatsink, so a fast NVMe drive will get hot during long transfers and will throttle. It is best suited to occasional use, data recovery and moving a drive between machines rather than as a permanent external disk. Check that your SSD is an M.2 drive of one of the listed lengths; mSATA, M.2 Key A/E Wi-Fi cards and 2.5-inch SATA drives will not fit.
Technical Specifications
| Host interface | USB 3.1 Gen 2, up to 10 Gbps (backward compatible with USB 3.0 / 2.0) |
| Host connector | USB-A male, integrated in the PCB |
| Drive support | M.2 NVMe (M key, PCIe) and M.2 SATA (B+M key) |
| Drive lengths | 2230, 2242, 2260, 2280 |
| Features | UASP, TRIM, plug and play - no drivers |
| Capacity stated by maker | Up to 2 TB |
| Operating systems | Windows, macOS, Linux |
| Board size | Approx. 11 x 2.5 cm |
| In the box | Adapter board, mounting screws, small screwdriver |
| Housing | None - bare PCB |