Skip to Content

Waterproof CCTV Camera Junction Box | Universal Outdoor Base Mount

A round white junction box that mounts between a CCTV camera and the wall or ceiling, so every cable join, connector and spare loop is hidden inside instead of hanging in the open. The universal hole pattern on the top face lines up with most dome and bullet camera bases, which makes it a straightforward upgrade for an existing installation.

  • Round base mount and junction box for CCTV / IP cameras
  • Universal hole pattern with numbered positions, fits most dome and bullet camera bases
  • Three side cable entries plus a central cable hole through the lid
  • Hollow body hides BNC and DC connectors, cable joins and slack
  • Moulded white plastic for indoor or outdoor wall and ceiling mounting
  • Approximate size: 120 mm diameter x 53 mm high
Price
15.00 LE 15.00 LE

Product Overview

On most camera installations the untidy part is not the camera, it is everything behind it: the BNC and DC connectors, the taped joint, and the half metre of spare cable that has nowhere to go. This junction box solves that by sitting between the camera base and the surface. The camera screws onto the top face, the cable passes down through the central hole, and all of the connections sit inside the body where they are out of sight and out of the weather.

The top face carries a dense pattern of mounting holes with numbered reference positions, so the same box lines up with the bolt spacing of most dome and bullet camera bases rather than being tied to one brand. Three cable entries are moulded into the side wall for surface-run conduit or cable, and the body is deep enough to hold a cable joint or a small power adapter. It mounts on a wall or a ceiling, indoors or outdoors, and the moulded white plastic matches the finish of a standard white camera housing.

Before ordering: measure the bolt spacing on your camera base first - the hole pattern is universal but not infinite, and very large or non-standard bases may not line up. The size below is approximate and taken from the manufacturer drawing, so check it against your camera if clearance is tight. No IP rating is published for this item, so for an exposed outdoor position seal the cable entries and the joint inside with self-amalgamating tape or a gland.

Technical Specifications

TypeCCTV camera junction box / base mount
ShapeRound, two-part body with removable lid
Mounting patternUniversal multi-position hole array with numbered reference points
Cable entries3 x side entries + 1 x central hole in the lid
FitsMost dome and bullet CCTV / IP cameras
Mounting surfaceWall or ceiling
MaterialMoulded plastic
ColourWhite
Size (approx.)120 mm diameter x 53 mm high
UseHides cable joins, connectors and slack behind the camera