Skip to Content

USB 3.1 Gen 2 to M.2 NVMe SSD Converter Adapter 10Gbps PCIe Based M Key Hard Drive Reader Support UASP Trim Dual Protocol NVMe SATA M2 SSD Board for M.2 2230 2242 2260 2280 SSD

This bare-board adapter turns a spare M.2 SSD into a pocket USB drive. The SSD screws onto the board and the board plugs straight into a USB-A port - there is no cable and no separate power supply. It reads both NVMe (PCIe) and SATA M.2 drives, so one board covers almost any M.2 SSD pulled out of a laptop or desktop.

  • Interface: USB 3.1 Gen 2, up to 10 Gbps, USB-A plug built into the board
  • Dual protocol: accepts M.2 NVMe (M key) and M.2 SATA (B+M key) SSDs
  • SSD lengths supported: 2230, 2242, 2260 and 2280
  • UASP and TRIM supported; plug and play, no drivers needed
  • Board size roughly 11 x 2.5 cm; mounting screws and a small screwdriver included
  • Works with Windows, macOS and Linux
Price
225.00 LE 225.00 LE

Product Overview

Most people who upgrade a laptop end up with a perfectly good M.2 SSD sitting in a drawer. This adapter is the cheapest way to put it back to work: lay the drive into the socket, fix it with the supplied screw, and the whole thing becomes a USB stick that is far faster and far larger than any flash drive. The USB-A plug is part of the circuit board itself, so there is nothing to carry except the board and the drive.

The bridge chip handles both of the protocols M.2 drives use. An NVMe drive, which is the M-key type with a single notch, runs over PCIe; a SATA M.2 drive, the B+M key type with two notches, runs over SATA. The board detects which one is fitted, so you do not have to buy a different adapter for each. On a USB 3.1 Gen 2 port it negotiates 10 Gbps and supports UASP for proper command queueing and TRIM so the drive can keep itself tidy. Plugged into an older USB 3.0 port it still works, just at 5 Gbps.

Before ordering: this is an open circuit board, not a closed enclosure - there is no case, no shielding and no heatsink, so a fast NVMe drive will get hot during long transfers and will throttle. It is best suited to occasional use, data recovery and moving a drive between machines rather than as a permanent external disk. Check that your SSD is an M.2 drive of one of the listed lengths; mSATA, M.2 Key A/E Wi-Fi cards and 2.5-inch SATA drives will not fit.

Technical Specifications

Host interfaceUSB 3.1 Gen 2, up to 10 Gbps (backward compatible with USB 3.0 / 2.0)
Host connectorUSB-A male, integrated in the PCB
Drive supportM.2 NVMe (M key, PCIe) and M.2 SATA (B+M key)
Drive lengths2230, 2242, 2260, 2280
FeaturesUASP, TRIM, plug and play - no drivers
Capacity stated by makerUp to 2 TB
Operating systemsWindows, macOS, Linux
Board sizeApprox. 11 x 2.5 cm
In the boxAdapter board, mounting screws, small screwdriver
HousingNone - bare PCB