Product Overview
This aluminium foil tape is a single-sided silver foil tape, 30 mm (1 inch) wide, coated with a heat-resistant pressure-sensitive adhesive and supplied on a paper release liner. The solid aluminium backing gives it the properties ordinary cloth or plastic duct tape does not have: it reflects radiant heat, forms a vapour and moisture barrier, and does not dry out or shrink away from warm surfaces the way a rubber-backed tape can.
It is the standard tape for sealing joints and seams on HVAC ducting, flexible ducts, dryer and extractor vent pipes, water-heater flues, foil-faced insulation boards and reflective insulation blankets. It also works for heat shielding, light foil repairs and any job where a thin, conformable metal tape is needed. The foil moulds around corners and round pipes and can be cut with scissors or a knife for a clean edge.
How to apply: clean and dry the surface first – dust, oil and condensation are the usual reasons foil tape lifts. Peel the paper liner, lay the tape down without stretching it, then press it firmly along its whole length so the adhesive wets out the surface. Overlap the previous strip by at least 25 mm on duct seams.
Technical Specifications
| Product type | Single-sided aluminium foil adhesive tape |
|---|---|
| Backing material | Aluminium foil (solid, non-reinforced) |
| Tape width | 30 mm (1 inch nominal) |
| Adhesive | Heat-resistant pressure-sensitive adhesive |
| Liner | Peel-off paper release liner |
| Colour / finish | Silver, metallic |
| Key properties | Heat resistant, heat reflective, moisture and vapour barrier, conformable |
| Typical uses | HVAC and flexible duct seams, dryer and extractor vents, water-heater and flue pipes, foil-faced and reflective insulation, heat shielding, foil repairs |