Skip to Content

SATA Power Extension Splitter Cable 15-Pin Male to 5x Female - Flat 18 AWG Cord for HDD, SSD & Optical Drives (50 cm / 1.6 ft)

A flat 50 cm SATA power splitter that turns a single 15-pin SATA output from your power supply into five. It is the quick fix for a desktop or NAS build where the case still has free drive bays but the PSU has run out of SATA leads.

  • One 15-pin SATA male plug to five 15-pin SATA female sockets
  • Total length 50 cm (1.6 ft) - long enough to reach across a mid-tower drive cage
  • 18 AWG oxygen-free copper conductors with braided copper shielding
  • Carries the full SATA power set: 3.3 V, 5 V and 12 V rails
  • Works with SATA I / II / III hard drives, SSDs, optical drives and SATA-powered expansion cards
  • Flat parallel ribbon in a flexible PVC jacket, latching connectors, black
Price
125.00 LE 125.00 LE

Product Overview

Desktop power supplies almost always ship with fewer SATA power leads than a loaded case can take. Add a second SSD, a third mechanical drive, an optical drive or a SATA-powered expansion card and you run out of connectors long before you run out of bays. This splitter solves that from one spare port: a single 15-pin SATA male plug feeds five 15-pin SATA female sockets, spaced along the cable so each one lands on a different drive in the cage.

The cable is built as a flat parallel ribbon rather than a round bundle, so it lies against the drive cage and tucks behind the motherboard tray instead of fighting the side panel. Inside it runs 18 AWG oxygen-free copper with a braided copper shield, and every connector uses the standard latching SATA body so a drive does not drop off the rail when you move the case. All three SATA voltages are carried through - 3.3 V, 5 V and 12 V - so the drives on the far end behave exactly as they would plugged straight into the PSU.

Before ordering: this cable splits power, it does not create it. Check that your power supply has the headroom for every drive you intend to hang off it - mechanical hard drives draw the most on spin-up, so a rail already close to its limit can trip under load. Also confirm your PSU has a free standard 15-pin SATA power connector; it will not fit a 4-pin Molex or a PCIe power lead.

Technical Specifications

TypeSATA power extension and splitter cable
Input connector1 x SATA 15-pin power, male
Output connectors5 x SATA 15-pin power, female
Total length50 cm (1.6 ft)
Conductor18 AWG oxygen-free copper
ShieldingBraided bare copper
JacketFlexible PVC, flat parallel ribbon
Voltages carried3.3 V / 5 V / 12 V
Connector designLatching, standard SATA power body
Compatible withSATA I / II / III HDDs, SSDs, optical and DVD drives, SATA-powered expansion cards
ColourBlack