Skip to Content

3.5mm AUX to USB Female OTG Audio Adapter Cable - 15cm

A short white lead with a 4-pole 3.5 mm plug on one end and a USB 2.0 Type-A socket on the other. It is a passive cable with no chip inside, made for car head units and MP3 decoder boards whose 3.5 mm socket is wired internally to read a USB flash drive.

  • 3.5 mm male, 4-pole (TRRS) → USB 2.0 Type-A female
  • Approximately 15 cm long, white PVC jacket
  • Completely passive — no decoder, DAC or electronics of any kind
  • Works only where the head unit supports reading a USB drive through its AUX socket
  • Does not connect USB headphones, speakers or sound cards to an AUX jack
  • Does not charge anything and does not transfer data to a computer
Price
40.00 LE 40.00 LE

Product Overview

This is a short white adapter lead: a four-pole 3.5 mm jack plug at one end, a full-size USB 2.0 Type-A socket at the other, and roughly 15 cm of cable between them. There is nothing inside it — no decoder chip, no digital-to-analogue converter, no power circuitry. The four contacts on the jack plug are simply wired through to the four pins of the USB socket.

That matters, because 3.5 mm audio and USB are two completely different kinds of signal: a 3.5 mm socket carries an analogue audio waveform, while USB carries digital data. A piece of wire cannot translate between them. The one situation where this cable earns its place is a car stereo or MP3 decoder board whose 3.5 mm socket has been wired by the manufacturer to act as a USB port for a flash drive. On those specific units — common on inexpensive aftermarket Chinese head units and amplifier boards — this lead gives you a normal USB socket to plug the drive into. On anything else it will do nothing at all.

Before ordering: check that your head unit is documented as reading a USB drive through its AUX socket. This cable will not play a flash drive through an ordinary AUX input, will not let USB headphones, USB speakers or a USB sound card plug into a 3.5 mm jack, will not charge a phone, and will not work with a computer, phone, camera, monitor or microphone. Despite the wording that is commonly used for this item online, it is not a USB On-The-Go (OTG) host adapter and it is not a converter.

Technical Specifications

Connector A3.5 mm male jack, 4-pole (TRRS)
Connector BUSB 2.0 Type-A female socket
Cable lengthApproximately 15 cm
ConstructionPassive pass-through wiring — no chip, no DAC, no power circuitry
Power requiredNone
JacketWhite PVC
ColourWhite
Intended useCar head units and MP3 decoder boards whose 3.5 mm socket is wired as a USB port
Not suitable forUSB headphones, USB speakers, USB sound cards, charging, PCs, phones, cameras, monitors, microphones
In the box1 × adapter cable